Parking barrier part is a key part of the equipment operation, then, how do encounter parking barrier internal parts of the problem? The Ji'nan parking lot management system for small finishing an article on the internal parts and measures of solving problems, we hope to help!
The first situation: screw loose: live joint screws for positive and negative thread connection, the upper and lower two bearings with double headed screw connection, if the screw loose, will cause the upper and lower is not accurate. Double headed screw rotating between the brake lever adjustment under the sword bit can be inserted with a long iron bar #4 80MM.
Second: the crank arm screw loose: if the screws are loose, will cause the brake lever and stop rod is not accurate when a large rock, the bolt hanging tight, tighten the nut.
Third: the lower hook screw loosening: hook is used to pull down the zero balance mechanism of the spring and the adjustment of the balance function, the top of the screw if loose, will cause the imbalance caused by other components such as load reducer, motor, thus affecting the service life of the gate, the solution is to tighten it good.
Fourth cases: place control magnet move position: upper and lower positions are adopted Tzu Holzer components, if the rectangular magnet and reducer with cam disk position change, resulting in inaccurate. Adjust it accurately, not scraping, and solve the problem.
Fifth: the coil catgut embedding loose: local sense coil can not be firmly fixed in the nest, the car off the road vibrations will cause the deformation of the coil inside the nest, sense of change in the initial inductance, the sensor must be reset back to work properly. The solution is to pour the melted asphalt into it and secure it.